1. After drawing the contours of the bases on plywood, both boards should be folded into a bundle and temporarily joined with nails.
2. In the corners of the resulting figures, 10-millimeter holes are drilled for the jigsaw blade.
3. The contours of the base are cut with a jigsaw with a work table.
4. Bench slats should be cut using a miter saw and a miter box. The work is facilitated by the use of a board with a stop block for this activity.
5. Smooth all edges with a file, and then two types of sandpaper.
6. It is best to cut the slats in series. The holes for the screws should be drilled with a drill with a diameter 3 mm and widen them with a countersink.
7. The strips should be primed white, and then paint every second one with a different color.
8. Mounting bases should be placed vertically using the mounting bracket, clamps and clamps, and then arrange the slats on them, make holes, put the screws into them and tighten.
The mesh should be marked on the plywood (mesh size 2 x 2 cm) and freehand draw the contours of the base.
We will need:
plywood 2 pcs. 29 x 19 x 1 cm
pine slats 13 pcs. 40 x 2 x 1 cm
lenticular screws 26 pcs. 3 x 20 mm
multi-colored varnishes acrylic nails 20 mm
fixing support 32 x 19 x 1,9 cm
fences 2 pcs. 19 x 3 x l,9 cm
line
ekierka
hammer
drill with a stand
wood drill bits
countersink
jigsaw with a work table
wooden wedges
sandpaper 80, 220
back saw with miter box
varnish brush
spring compression 40 cm
screwdriver